Atık Trafo Yağı ve Dizel Yakıt Karışımlarının Karakterizasyonu ile Motor Performans ve Egzoz Emisyon Parametrelerinin Tek Silindirli Dizel Bir Motorda Deneysel Olarak İncelenmesi
Thesis Type: Postgraduate
Institution Of The Thesis: Ataturk University, Fen Bilimleri Enstitüsü, Makine Mühendisliği Anabilim Dalı, Turkey
Approval Date: 2023
Thesis Language: Turkish
Student: NİHAT SAMİ ŞEN
Supervisor: İlhan Volkan Öner
Open Archive Collection: AVESIS Open Access Collection
Abstract:Purpose: With the master's thesis that will emerge with this thesis study; Investigation of the characterization of the fuel components obtained by homogeneously mixing the diesel used in diesel engines with residual transformer oil in certain proportions and examining the expected performance parameters and emission values in the case of using these fuels in a diesel engine, and using their properties as an alternative fuel in internal combustion diesel engines. Method: The thermochemical properties of the fuel obtained by mixing 10%, 20%, 30% and 40% of the spent transformer oil used as heat transfer fluid with diesel fuel (TD10, TD20, TD30 and TD40, respectively) were investigated. Prepared 5 different fuel samples were tested in a four-stroke, single-cylinder, air-cooled diesel engine at 1000-1500-2000 and 2500 rpm at full load. In the experiments, exhaust emission values and exhaust gas temperature measurements were made for all mixtures and braking power, torque and brake specific fuel consumption values were calculated. Findings: At all engine speeds, the average torque and brake power values produced by each fuel were highest in the D100 fuel, while the lowest torque and brake power values were observed in the TD40 fuel with rates of 14.03% and 16.01%, respectively. Among the TD blends, TD10 had the best average torque and brake power values. Among the TD blends, the lowest average BSFC value was obtained from the TD10 blend (214.52 g/kWh) et al speeds, while the highest average BSFC was obtained from the TD40 blend (261.83 g/kWh). In general, BSFC has increased depending on density and calorific value. Among all blends, the lowest average CO emissions were observed in the TD10 fuel blend, while the highest average CO emissions were observed in the TD30 fuel blend. Compared to diesel fuel, NOx emissions showed a 23.98% reduction at most in TD30 fuel. The highest average EGT value was measured for the TD40 fuel (509.38°C), while the lowest EGT value was measured for the TD10 fuel (471.90°C). Results: All fuel mixtures; Important fuel components such as configuration, viscosity, pour and cloud point met ASTM or EN standards. According to the high viscosity, fastness and low calorific values of waste transformer oil, which has completed its life, it has criterion values compared to diesel fuel. In terms of chemical analysis results, the standards criteria required for diesel engines of all waste transformer oil mixtures have been changed. By using the spent transformer oil as fuel in the diesel engine, CO and NOx emissions are recovered. Keywords: End of Life Waste Transformer Oil, Alternative Fuel, Engine Performance, Exhaust Gas Emissions