Experimental and computational fluid dynamics analysis of a photovoltaic/thermal system with active cooling using aluminum fins

ÖMEROĞLU G.

JOURNAL OF PHOTONICS FOR ENERGY, cilt.7, sa.4, 2017 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 7 Sayı: 4
  • Basım Tarihi: 2017
  • Doi Numarası: 10.1117/1.jpe.7.045503
  • Dergi Adı: JOURNAL OF PHOTONICS FOR ENERGY
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Anahtar Kelimeler: photovoltaic/thermal solar cells, fins, electrical efficiency, heat transfer, ANSYS Fluent, SOLAR AIR HEATER, WATER COLLECTOR, PV/T SYSTEMS, PERFORMANCE, EFFICIENCY, MODULE, FLOW, HOT, TEMPERATURE, CELLS
  • Atatürk Üniversitesi Adresli: Evet

Özet

Being the most widespread renewable energy generation system, photovoltaic (PV) systems face major problems, overheating and low overall conversion efficiency. The electrical efficiency of PV systems is adversely affected by significant increases in cell temperature upon exposure to solar irradiation. There have been several ways to remove excess heat and cool down the PV to maintain efficiency at fair levels. A hybrid photovoltaic/thermal system cooled by forced air circulation blown by a PV-powered fan was set up, and a rectangular control volume with cylindrical ends was built at the back of the PV panel where aluminum fins were placed in different arrangements and numbers. During the experiments, temperature and electrical output parameters were measured for three different air velocities (3.3, 3.9, and 4.5 m/s) and two different fin numbers and arrangements (54 pcs shifted and 108 pcs inline) under a constant radiation value of 1350 W/m(2). While the electrical efficiency of the panel was reduced by almost 50% and decreased from 12% to 6.8% without active cooling, at 4.5-m/s air velocity and with 108 fins in inline arrangement, the electrical efficiency could be maintained at 11.5%. To compare and verify the experimental results, a heat transfer simulation model was developed with the ANSYS Fluent, and a good fit between the simulation and the test results was obtained. (C) 2017 Society of Photo-Optical Instrumentation Engineers (SPIE)