Electrical characteristics of atomic layer deposited Au/Ti/Al2O3/n-GaAs MIS structures over a wide measurement temperature

TURUT A., KARABULUT A., EFEOĞLU H.

JOURNAL OF OPTOELECTRONICS AND ADVANCED MATERIALS, cilt.19, ss.424-433, 2017 (SCI-Expanded) identifier identifier

  • Yayın Türü: Makale / Tam Makale
  • Cilt numarası: 19
  • Basım Tarihi: 2017
  • Dergi Adı: JOURNAL OF OPTOELECTRONICS AND ADVANCED MATERIALS
  • Derginin Tarandığı İndeksler: Science Citation Index Expanded (SCI-EXPANDED), Scopus
  • Sayfa Sayıları: ss.424-433
  • Anahtar Kelimeler: Metal/Insulating layer/semiconductor (MIS) structures, Atomic layer deposition (ALD), Inhomogeneous barrier height, GaAs semiconductor, current-voltage of MIS structures, CURRENT-VOLTAGE CHARACTERISTICS, SCHOTTKY-BARRIER DIODES, DOUBLE-GAUSSIAN DISTRIBUTION, I-V CHARACTERISTICS, SEMICONDUCTOR DEVICES, THIN-FILMS, CONTACTS, HEIGHT, DEPENDENCE, GAAS
  • Atatürk Üniversitesi Adresli: Evet

Özet

We have prepared the Au/Ti/Al2O3/n-GaAs structures and investigated their current-voltage (I-V) characteristics with the temperature (in 20-320K range) as a parameter, and current-temperature (I-T) characteristics with bias voltage as a parameter. The ultrathin Al2O3 metal-oxide layer on the n-GaAs substrate has been formed by atomic layer deposition (ALD) method. Ti(10nm) rectifying contacts have been fabricated on Al2O3/n-GaAs structure by DC magnetron sputtering. The ideality factor value has remained between 1.10-1.06 from 130 K to 320 K. The barrier height (BH) value has increased with a slope of alpha = -0.31 meV/K from 320 K to 110 K. Then, it has been seen that the decrease in the BH value from 110 K to 20 K obeys a double Gaussian distribution (GD) of the BHs due to the BH inhomogeneity. The experimental I-T characteristics have been interpreted by plotting the theoretical I-T characteristics with and without the GD based on the TE current theory at each bias voltage. Moreover, the BH values have been also determined from the Richardson curves plotted using the I-T data at each forward and reverse bias voltage. It has been observed that the BH reduction is higher under reverse bias voltage than under forward bias voltage regime due to the barrier inhomogeneity which is not recommended for the Schottky diode being a rectifying device.